wats the best dremel bit to use? to trim masks like on the join line and stuff
iv been using little scissors to trim mine but it takes ages to do like this
i always use a diamond cutting wheel on my dremel for cutting anything. i’m not sure how it would work on a mask though. it may heat it up and melt it. trial and error i guess.
Actually I use the nylon brush for this but it will still burn the mask if there’s too much RPM. The metal wire brush is a definite no-no and not needed if you have the nylon one. Works great but be very careful or it will leave bad spots… or holes 
JC
i use the felt tip looks like a bullet.after i dremel a spot i take a rag with some naptha and wipe it. this will get all the bugers off and leave it clean and smooth…tommy
I always use the felt tip too.they have round ones and the bullet shaped ones like tommy said.Just dont rev it up to much.
thx for the help guys 